2N Lift8 Camera module
2N Lift8 Camera Module is a recording device that once linked up to any IP, RS232 or RS485 camera, captures images from the lift cabin or monitored space. This is then saved at set intervals to the microSD memory card located in the camera module. The camera module can be used not only with the 2N Lift8 system, but also as a standalone unit.
Related Products
2N Lift8 – I/O Module
Module with four logical inputs, and four relay outputs. On one central...
2N Lift8 – Audio Unit COP, Cable version
COP version of the cabin audio unit for installation behind the panel.
2N Lift Induction Loop Amplifier, 1 Audio Input
Emergency lift communication for the hearing-impaired. The Induction Loop for Lifts is...
2N Lift8 Pictogram driver
The device transforms LED outputs of 2N’s Lift8 Car Unit into a...
2N Lift8 – RS232 Module
The RS232 module is used for the connection and communication of the...
2N Lift8 Audio Evacuation Unit for MEEF
The MEEF (Main Elevator Evacuation Floor) evacuation unit is part of an...
2N Lift8 – Central Unit
A highly modular elevator communication system, where the two-wire bus makes the...
2N Lift8 – Audio Unit Shaft
Audio unit to be installed in the lift shaft or upon the...
2N Lift8 – Antivandal Cabin Plate
The electronics of the audio unit for installation in a lift cabin...
2N Lift8 – Splitter
For connection of next lift. On one central unit can be up...
2N LiftIP 2.0 Voice Alarm Station Set
The 2N LiftIP 2.0 Voice Alarm Station Set audio unit is intended...